www.HunterFan.com
1.888.830.1326
Troubleshooting
Excessive wobbling
• Tighten all of the blade and
blade iron screws until they
are snug.
• Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
• Use the provided balancing
kit and instructions to balance
the fan.
Noisy Operation
• Tighten the blade and blade
iron screws until they are snug.
• Check to see if any of the
blades are cracked. If so, replace
all of the blades.
Fan doesn’t work
• Make sure power switch is on.
• Pull the pull chain to make sure
it is on.
• Push the motor reversing switch
rmly left or right to ensure that
it is engaged.
• Check the circuit breaker to
ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 9-10.
• Check the plug connection in
the switch housing.
If you wish to operate multiple fans with one plug-in controller:
1. You will need an additional compatible receiver (sold separately)
installed in each fan. Receivers can be purchased at www.HunterFan.com.
2. Complete the entire Setup process below for the rst fan.
3. Once setup is complete for the rst fan, tap the Gear icon on the main screen to
navigate to the “Rooms Congured” settings screen.
4. For each additional fan, perform steps 7-10 on this page to complete setup.
20
M3644-01 • 02/01/17 • © 2017 Hunter Fan Company
To Previous Page
