1. Getting Started
This manual provides operation instructions and informa-
tion required to operate the SmartWeight® Elite.
Read and become familiar with the contents of this man-
ual prior to operating the equipment. The owner of this
equipment is solely responsible for arranging technical
training.
The SmartWeight® Elite is to be operated only by quali-
fied trained technicians. Maintaining records of personnel
trained is solely the responsibility of the owner and man-
agement. This manual assumes the technician has al-
ready been trained in basic balancing procedures.
1.1. Corporate Information
Hunter Engineering Company
11250 Hunter Drive
Bridgeton, MO 63044 USA
Phone: 314-731-3020
web: www.Hunter.com
2. For Your Safety
2.1. Hazard Definitions
Watch for these symbols:
CAUTION
Caution: Hazards or unsafe practices,
which could result in minor personal
injury or product or property damage.
WARNING
Warning: Hazards or unsafe practices,
which could result in severe personal
injury or death.
DANGER
Danger: Immediate hazards, which
will result in severe personal injury or
death.
These symbols identify situations that could be detrimen-
tal to your safety and or cause equipment damage.
2.2. Important Safety Instructions -
Electrical
Do not operate equipment with a damaged cord or equip-
ment that has been dropped or damaged until examined
by a Hunter Service Representative.
If an extension cord is necessary, it must have a current
rating equal to or more than that of the equipment. Cords
rated for less may overheat. Arrange the cord so that it will
not be tripped over or pulled.
Never use the cord to pull the plug from the outlet
Verify that the electrical supply circuit and the receptacle
are properly grounded.
To reduce the risk of electrical shock, do not use on wet
surfaces or expose to rain.
Verify the appropriate electrical supply circuit is the same
voltage and amperage ratings as marked on the equip-
ment before operating.
WARNING
DO NOT ALTER THE ELECTRICAL
PLUG. Plugging the electrical plug in-
to an unsuitable supply circuit will
damage the equipment and may result
in personal injury.
When servicing the SmartWeight® Elite, power must be
disconnected by removing the power cord from the electri-
cal outlet. Ensure that the SmartWeight® Elite power
switch is in the off position ("O" position) before plugging
the power cord into the electrical power outlet.
2.3. Important Safety Instructions -
Operation
To reduce the risk of fire, do not operate equipment near
open containers of flammable liquids (gasoline). Read and
follow all caution and warning labels affixed to your equip-
ment and tools. Misuse of this equipment can cause per-
sonal injury and shorten the life of the equipment. Keep all
instructions permanently with the unit. Keep all decals, la-
bels, and notices clean and visible. To prevent accidents
and/or damage to the Balancerrecommended accesso-
BM07900-00 SmartWeight® Elite Operations Manual
Page 3 of 7
To Next Page
Loading...
