7
8
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Canopy Screw
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Installing the Bulbs and Glass
ON
Turn Power
Install a bulb into each of the sockets. When
necessary, replace with bulbs of same wattage.
To install the cage, rst loosen
the thumb screws. Raise the
shade to the light xture. Tighten
all thumbscrews securely.
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs and click “How do I install my
fan without the light kit?”
Hunter Pro Tip:
Repeat x3
Repeat x3
Fan style may vary.
Note:
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
1 of 3
Light Kit Screw
bag
2 of 3
Light Kit Screw
bag
1
STEP
2
STEP
3
STEP
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Install the three switch housing screws
found in the hardware bag.
x3
Switch Housing
Screw
bag
4
STEP
5
STEP
6
STEP
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
To Next Page
Loading...
Need help?
General
