Hunter Swanson - Ceiling Bracket Installation; Outlet Box Mount (Machine Screws); Building Structure Mount (Wood Screws); Fan Wiring Connections

3
4
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass
Check the outlet box:
Installing the Ceiling Bracket
Use wood screws and
washers (included)
when securing to
support structure with
approved electrical
outlet box. Drill 9/64”
pilot holes in support
structure to aid in
securing ceiling
bracket with hardware
found in the
hardware bag.
Use machine screws
(provided with outlet box)
and washers when securing
to existing ceiling fan-rated
outlet box. Make sure it is
securely installed and is
acceptable for fan support of
31.8 kg (70 lbs) or less.
Option 2:
Wood Screws
Option 1:
Machine Screws
OFF
Turn Power
Do this rst!
Box Outlet Mount
Building Structure Mount
The machine screws are the ones
that came with your outlet box.
Hunter Pro Tip:
For angled ceilings,
point opening
toward peak.
ANGLED
MOUNTING TIP
bag
Wood Screw
Washer
x2
x2
You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box.
WARNING
•To avoid possible electrical shock, before installing
your fan, disconnect the power by turning off the circuit
breakers to the outlet box associated with the wall switch
location.
•All wiring must be in accordance with national and local
electrical codes ANSI/NFPA 70. If you are unfamiliar with
wiring or in doubt, consult a qualied electrician.
•The ceiling fan must be grounded. If the ground wire for
the installation site is not present, immediately STOP
installation and consult a qualied electrician.
2
1
1
2
Wiring the Fan
Connect wiring from ceiling to terminal block (on
side of canopy mount) and tighten using athead
screwdriver (included).
Single Switch Wiring
Green, Green Yellow Stripe, or Bare (grounding)
Black (ungrounded) L1
White (grounded) N