Hunter Swanson User Manual

5
6
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass
Installing the Downrod
Hand tighten the downrod
(at least 4-5 full turns)
until it stops.
Hanging the Fan
S
l
i
d
e
c
a
n
o
p
y
o
v
e
r
d
o
w
n
r
o
d
a
n
d
w
i
r
e
s
.
Place the downrod ball into
the slot in the ceiling bracket.
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing.
NOTICE
Make sure wires are not being
tangled while twisting.
K
E
E
P
!
Back out the pre-installed
setscrew so that the setscrew’s
threads are still engaged while
the shank does not protrude
and obstruct the insertion of the
downrod.
DO NOT
REMOVE
SETSCREW
COMPLETELY
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
Follow below if you are using the downrod that came pre-assembled in your box. Need to install a longer or shorter downrod? Check out the
guide at the end of this manual.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
• Pin must be reinserted to secure
downrod assembly
Remove product from packaging.

Hunter Swanson Specifications

General

Brand	Hunter
Model	Swanson
Category	Fan
Language	English