Hunter Thermostat User Manual

Snap open the wallplate from your thermostat by pressing the release tab on the bottom of
the thermostat.
Position wallplate on wall and pull existing wires through large opening. Then level for
appearance. Mark holes for plastic anchors provided if existing holes do not line up with
Hunter Thermostat holes.
Drill holes with 3/16" bit and gently tap anchors into the holes until flush with wall.
Reposition wallplate to wall, pulling wires through large opening. Insert mounting screws
provided into wall anchor and tighten. (See Figure 2.)
Mount Wallplate and Thermostat
Figure 2

Hunter Thermostat Specifications

General

Compatibility	Most HVAC systems
Connectivity	Wi-Fi
Scheduling	7-day programmable
Voice Control	Amazon Alexa, Google Assistant
Power Source	Battery, Hardwired
Energy Reports	Yes