Need help?Do you have a question about the HunterDouglas Vertiglide Duette Honeycomb and is the answer not in the manual?
General| Brand | HunterDouglas |
|---|---|
| Model | Vertiglide Duette Honeycomb |
| Category | Indoor Furnishing |
| Language | English |
Identify shade design, mount type (inside/outside/ceiling), and valance type for correct installation.
Measure and mark bracket placement for outside mounts, spacing 8" from ends and evenly.
Install headrail by aligning and snapping into brackets, then prepare and install vertical rails.
Secure stationary rails using brackets, ensuring verticality and proper mounting surface attachment.
Mount brackets and shims for inside/ceiling mounts, spacing 8" from ends and ensuring level alignment.
Install components like rail clips and moving rail brackets into the headrail.
Install the headrail by pushing it up into the mounting brackets until it clicks.
Prepare and install vertical rails, including the stationary rail bottom bracket and stationary rail.
Secure stationary rails using brackets, ensuring verticality and proper mounting surface attachment.
Prepare rails and install the stationary rail bottom bracket for traditional mounts.
Install vertical rails, including removing end plates and inserting center pull plates.
Install headrail by measuring centerpoints, aligning marks, and snapping into brackets.
Secure stationary rails for traditional outside mounts using brackets.
Release slip knot, pull cord for tension, re-tie knot, and trim excess cord.
Test shade slide and holding, adjust cord tensioner to ensure smooth operation and position hold.
Check and adjust vertical rail alignment using the moving rail bracket adjustment lever.
Adjust bottom rail alignment left or right by loosening and tightening specific screws.
Attach valance clips to the valance, assemble returns, and attach the valance to the headrail.
Attach valance clips to headrail, attach corner brackets to valance, and align dovetail brackets.
Perform regular light dusting with a feather duster for routine cleaning.
Use a hand-held vacuum with low suction for more thorough dust removal.
Dab spots with a damp cloth and mild detergent; do not rub fabric.
Immerse shade in mild detergent, rinse, drain excess water, and let it dry completely.
Use mild detergent solution and dry the shade in the extended position.
Professional cleaning using injection/extraction method, check fabric for specific requirements.
Adjust cord tension or check for pinched cord if the shade binds or moves with difficulty.
Increase cord tension by sliding the cord tensioner toward the fabric stack.
Adjust screws on the moving rail to correct the vertical alignment of the shade.
Use extension brackets or spacer blocks for adequate clearance with moldings or cranks.
Add shims to installation brackets to provide extra space for headrail and valance attachment.
Reattach fabric carriers by placing, aligning, and snapping them closed between fabric cells.
Scrape paint from the channel or use a valance bracket as a stop for the cord tensioner.
Gently adjust moving rail to correct alignment and fabric bow towards or away from the window.
To Next Page