14
3.6 Description of Controls
Controls
Description
ON/OFF/STANDBY Key
• Press this button to start the system – the system status indicator will
illuminate green.
• When in measurement mode, press this button to enter standby
mode – the system indicator changes to amber.
• To switch OFF, press and hold this button for 2s.
Return key
Error code clearance
• Press this key to clear any error code which may be displayed when
in measurement mode.
Save measurement
• Press this key to save measurement to memory
Memory re-call
• Press and hold this key for 2s to access stored measurements in the
memory
Pulse tone enable / disable
• Press and hold this key for 4s to enable the pulse tone setting (on / off)
Maintenance mode selection
• Press this key within 10s of power up to enter the maintenance mode.
Patient Group select key
Patient selection
• Press this key to select the relevant patient group.
Start/Stop NIBP Measurement
• Press this key to initiate a blood pressure measurement, If the button
is pressed during a measurement, the measurement will stop.
Description of Controls, Indicators, Symbols and Displays
To Next Page
Loading...