Hurco VM30 - Page 113

VM Series Maintenance and Safety Manual 704-0212-209 Index — 3
maintenance
coolant 3-25
daily 3-2
preventive 3-1
routine 3-1
scheduled 3-1
spindle 3-13
manual jog
feed keys 1-31
hand wheel 1-31
Manual Mode
enclosure doors open 2-7
operations 2-7
manual pulse generator 1-30, 1-31
Max console 1-29
messages
initialization error 3-39
Mode Selector buttons, LCD Remote Jog
Unit 1-31
Motion Hold button, LCD Remote Jog Unit
1-31
motion system, axes 1-12
motor brake 1-4
N
network 1-25
network port
ISA 1-27
ITX 1-21
noise levels 2-13
O
oil level
trunion table clamping system 3-30
trunion table rotary axis 3-31
trunion table tilt axis 3-32
operation and maintenance 2-11
operator
control console 1-28
training 2-10
P
paddle screws, chip conveyor 3-27
parts
ordering replacement 3-46
returning 3-46
personal care 2-12
persons trapped inside machine enclosure
2-9
pneumatic clamping system 1-34
pneumatic system 1-33
maintenance 3-22
requirements 3-22
port
network ITX 1-21
network, ISA 1-27
QWERTY keyboard 1-32
serial pin descriptions 1-26
power cabinet
over temperature 3-45
power supply
ISA 1-22
ITX 1-17
power-on self test 3-42
power-up
troubleshooting 3-39
pressure setting
way lube 3-6
preventive maintenance 3-1
printed circuit boards, handling 1-15
Program Entry keyboard 1-30
proximity sensor spindle orientation 1-10
Q
QWERTY keyboard port 1-32
R
rapid
+/- console keys 1-30, 1-31
feed control knob 1-30, 1-31
feedrates 1-13
Rapid Traverse
X and Y axes 1-13
Z Axis 1-13
rate selections, manual pulse generator
1-30, 1-31
Record of Changes -1
releasing a person trapped inside the ma-
chine enclosure 2-9
remote jog unit 1-30, 1-31
replace
rotary-axis oil, trunion table 3-31
tilt-axis oil, trunion table 3-32
replacement parts
ordering from full service distributor
3-46
return 3-46
reset PCB or machine 3-40
responsible conduct 2-11
Return Authorization Tag (RMA number)
3-46
rotary axis
oil level, trunion table 3-31
Rotary Axis Rotation Speed 1-13
rotary encoder 1-2, 1-14
run-in, spindle 3-36