4
SERVICE
□ H
ave your power tool serviced by a qualified
r
epair person using only identical replacement
p
arts. This will ensure that the safety of the
power tool is maintained.
□ N
ever service damaged BATTERY packs.
Service of BATTERY packs should only be
performed by the manufacturer or authorized
service providers.
SPECIFIC SAFETY RULES FOR
C
ORDLESS RATCHET
□ Know what is behind a workpiece before you
d
o the job. Do not cut into existing walls or other
blind areas where electrical wiring, water, or gas
pipes may exist. If this situation is unavoidable,
disconnect all fuses/circuit breakers, and shut off
any water and gas lines feeding this work site.
□ H
old the power tool by insulated gripping
s
urfaces, when performing an operation
w
here the fastener may contact hidden wiring
o
r its own cord. Fasteners contacting a “live”
wire may make exposed metal parts of the power
tool “live” and could give the operator an electric
shock.
□ A
void overload working.
□ D
o not touch bits, sockets, ratchet component
a
nd workpiece immediately after use. They
may be very hot and could burn skin when
touching them after use.
□ B
e prepared for a reaction torque when
“
seating” or removing a fastener. The tool
housing may tend to twist in the opposite
direction of bit rotation when “seating” or
removing a fastener, depending on the torque
setting of the tool.
□ D
o not use worn or damaged sockets and
a
ccessories. Insert the socket well onto the
a
nvil. Be sure that the socket has locked onto the
anvil correctly.
□ D
o not store or use the tool in locations where
the temperature may reach or exceed 140°F
(60°C), which can lead to deterioration of the
battery.
□ D
o not incinerate the tool even if it is seriously
d
amaged or is completely worn out. This tool
contains Li-Ion batteries, the batteries can
explode in a
.
IMPORTANT SAFETY RULES FOR
C
HARGER
□ To reduce the risk of electric shock or damage
t
o the tool and charger, only use the charger
(
model no. 7106) provided by the
m
anufacturer.
□ D
o not charge the tool if case is cracked or
d
amaged. Electric shock and can cause
injury.
□ D
o not expose charger to rain or snow.
□ T
his charger is not intended for any uses other
t
han charging the ratchet. Any other use may
result in risk of
re, electric shock or
electrocution.
□ D
o not disassemble charger. Take it to a
service person when service or repair is
required. Incorrect reassembly may result in a
risk of electric shock or
.
□ T
o prevent the risk of electric shock, unplug
t
he charger from the outlet before attempting
t
o clean it.
□ D
o not use the charger in locations where the air
temperature is below
32°F (0°C)
or above
. This is important and will prevent
to the battery and charger.
WARNING: To reduce the risk of injury,
user must read and understand instruction
manual.
WARNING: This manual contains
important safety and operating instructions
for your charger. Before using the charger,
read all instructions and warnings on the
charger and the tool.
WARNING: Always wear proper personal
hearing protection that conforms to ANSI
S12.6 (S3.19) during use.
104°F
(40°C)
To Next Page
Loading...
