Huskylock 340D - Needle Threading; Needle Threading Procedure

01/23/2008
NEEDLE
THREADING
Lastly
needle
must be
threaded.
Follow
the
‘path’
colored
GREEN
on chart
for
left
needle,
taking the
thread around
the green
tension
control
and
through the thread
guides
with
S
symbols.
Follow
the
‘path’ colored
YELLOW on
chart
for
right needle,
taking
the thread around
the
yellow
tension
control
and through the
thread
guide
with
4
symbols.
Pull check spring
up and past the pointed hook until
thread
can be slipped into the hook. When the
thread is released,
the
check
spring will return
to
original position with the thread in place.
Finally thread needle(s)
from FRONT to
BACK
and then under
the presser foot,
leaving about 10 cm of
thread(s).
Should
it
be
necessary
at any time to re
thread the
lower looper, ALWAYS
remove
thread(s)
from
needle(s)
first to avoid
tangling.
.t.
Check
spring