6
●
●
●
●
If there is still no spark, disconnect the ignition
switch wire from the on/off switch flag. Again,
rapidly pull the starter. If spark is now observed,
the problem is a faulty on/off switch assembly.
Install a new switch assembly.
If no spark is observed remove the starter assem-
bly, disconnect the switch wire at the module and
replace the starter (two screws should hold the
starter in place while trying this procedure).
Rapidly pull the starter. If spark is now observed
the switch wire is at fault.
If no spark is observed, check the high tension
lead to the spark plug.
Using the plastic air gap tool, check the air gap
between the flywheel magnet and the ignition
module laminates. The gap should be .012“.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
