7 CENTRIFIJGAL CLUTCH
@
. Install the piston-stop tool. Remove the clutch
assembly by tapping on a drift placed against one -
of the two knock-off holes provided. Tap in the
direction stamped on the clutch driver face.
. The clutch assembly consists of a “top hat” wash-
er, a driver, two shoes and two springs.
NOTE: The correct spring position is as shown to
ensure that the springs do not touch the clutch
drum.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
