10
● If the corm rod/piston assembly is removed from
the crankshaft, thoroughly clean all parts before
reassembly.
ASSEMBLY
.
Stand the crankshaft vertically (clutch end down).
Apply a heavy coat of grease to the crankpin
(big
end) journal. Place the II needle rollers in place
around the journal and carefully thread the big
end of the corm rod over the journal and
needles.
NOTE:
The piston must be installed with the
piston ring peg facing the flywheel end of the
crankshaft. This will ensure the ends of the ring
do not “clip” a portopeningin the cylinder.
● Slide the needle-type main bearings onto the
crankshaft.
NOTE: The lettered ends of the
bearing should face the crankshaft counterweight.
Place the clip rings on the crankshaft. Oil the
engine seals and carefully slide them over the
ends of the crankshaft . . .
watch that the ignition
side seal lip is not cut by the sharp edges of the
crankshaft keyway.
. Thoroughly clean and dry
crankcase/cylinder casting
end-cap. Apply a thin, even
the surfaces of the
and the crankcase
bead of RTV sealant
(or gasket elim-inator)to the sealing surfaces. Do
not allow excess sealantto block passages.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
