330i 535i XP
Equivalent sound pressure level at the operator's ear,
dB(A)
93 93
Vibration levels
3
Front handle m/s
2
3.5 4.1
Rear handle m/s
2
3.9 4.6
Equivalent vibration levels
4
Front handle m/s
2
2.2 2.5
Rear handle m/s
2
2.4 2.8
Saw chain/guide bar
Recommended bar lengths, inch/cm 10-14/25-35 10-14/25-35
Usable cutting length, inch/cm 9-13/23-33 9-13/23-33
Type of drive sprocket/number of teeth Spur/6 Spur/6
Maximum chain speed / (savE), m/s 15 (12) 20 (15)
Accessories
Guide bar and saw chain combinations
The following cutting attachments are approved for
Husqvarna 330i and 535i XP.
Guide bar Saw chain
Length, in Chain pitch, in Gauge, mm Max. nose radius Type Length, drive
links (no.)
10 3/8 1,1 7T Husqvarna H38 40
12 9T 45
14 52
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
3
Vibration level, according to EN 60745-2-13. Reported data for vibration level has a typical statistical disper-
sion (standard deviation) of 1 m/s
2
. Declared vibration data from measurements when the machine is fitted
with a bar length and recommended chain type. If the machine is fitted with a different bar length, the vibration
level may vary by max ± 1.5 m/s
2
.
4
Equivalent vibration level is measured and calculated as for combustion engine powered chainsaws. These
figures are quoted to be able to compare vibration data regardless of type of engine.
34 958 - 004 - 22.01.2019
To Next Page
Loading...
