Husqvarna 334T - Contents; Table of Contents

CONTENTS
English –
3
Contents
KEY TO SYMBOLS
Symbols on the machine: ..................................... 2
Symbols in the operator’s manual: ....................... 2
CONTENTS
Contents ............................................................... 3
INTR ODUCTION
Dear Customer , .................................................... 4
WHA T IS WHAT?
What is what on the chain sa w? ........................... 5
GENERAL SAFETY PRECA UTIONS
Bef ore using a new chain saw .............................. 6
Important .............................................................. 6
Always use common sense .................................. 6
Personal protective equipment ............................. 7
Machine ′ s safety equipment ................................. 7
Cutting equipment ................................................ 10
ASSEMBL Y
Fitting the bar and chain ....................................... 16
FUEL HANDLING
Fuel ...................................................................... 17
Fuelling ................................................................. 18
Fuel safety ............................................................ 18
ST ARTING AND STOPPING
Star ting and stopping ........................................... 19
W ORKING TECHNIQUES
Bef ore use: ........................................................... 21
General working instructions ................................ 21
How to avoid kickback .......................................... 28
MAINTENANCE
Carb urettor ........................................................... 29
Checking, maintaining and servicing chain saw
saf
ety equipment .................................................. 30
Muffler .................................................................. 32
Starter .................................................................. 32
Air filter ................................................................. 33
Spark plug ............................................................ 34
Lubricating the bar tip sprocket ............................ 34
Adjustment of the oil pump ................................... 34
Cooling system ..................................................... 34
Maintenance schedule ......................................... 35
TECHNICAL D ATA
T
echnical data ...................................................... 36
Bar and chain combinations, model 334T ............ 37
Bar and chain combinations, model 338XPT ....... 37
Saw chain filing and file gauges ........................... 37
EC-declaration of conformity ................................ 38