What to do if my Husqvarna 334T Chainsaw is difficult to start?
If your Husqvarna chainsaw is difficult to start, here are some potential solutions: * Adjust the L-screw. * Check if the air filter is blocked. * Examine the choke to ensure it is functioning correctly. * Inspect the choke axle and valve for wear. * Ensure the fuel filter and fuel line are not blocked. * Check for a seized piston ring or a blocked impulse channel.
Why is my Husqvarna 334T Chainsaw Carburettor leaking fuel?
If your Husqvarna chainsaw carburettor leaks fuel, it may be due to: * A loose or faulty fuel pipe. * A hole in the diaphragm. * A worn needle or needle tip. * A sticking control system. * A control system set too high. * A leaking control system (air or fuel). * A loose cover on the carburettor’s pump side.
What to do if my Husqvarna 334T does not idle?
If your Husqvarna chainsaw does not idle, consider the following: * Adjust the L-screw. * Check for a leaking inlet manifold (rubber) or loose carburettor mounting. * Inspect the fuel pipe for leaks or faults and ensure the fuel filter and fuel line are not blocked. * Make sure the tank ventilator is not blocked. * Examine the throttle valve axle for stiffness and ensure the throttle isn't sticking. * Check the throttle return spring for defects and the valve axle stop for bending. * Inspect for a faulty diffuser jet.
To Next Page
General
