English – 53
Assembly
Assemble as follows:
1. Lubricate and fit the pump piston (B), spring and washer.
Press in the unit and at the same time screw in the adjuster
screw (A) with the spring and washer.
OIL PUMP
Now assemble the following parts:
3. Cylinder and crankshaft. See the chapter "Crankshaft,
Piston and Cylinder".
4. Tank unit. See the chapter "Tank unit".
5. Ignition system and the spark plug. See the chapter
"Ignition system".
6. Starter. See the chapter "Starter".
7. Carburettor. See the chapter "Carburettor".
8. Muffler. See the chapter "Safety equipment".
9. Centrifugal clutch. See the chapter "Centrifugal clutch".
10. Bar and chain. See the Operator Guide.
11. Test run the chain saw and check the oil flow. See the
Operator Guide.
C
D
2. Fit the guide (C) and cover plate (D).
A
B
F
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
Need help?
General
