Why does my Husqvarna 455 Rancher Chainsaw require constant L screw adjustment?
If the L screw on your Husqvarna chainsaw requires constant adjustment, check for a blocked fuel line, ensure the needle valve is not set too high, and inspect for a sticking needle valve assembly. Also, look for leaks in the metering system, a leaking control diaphragm/cover plate, faulty diffuser jets, and a crankcase leak.
Why does my Husqvarna 455 Rancher Chainsaw have too much fuel at idling?
If your Husqvarna chainsaw has too much fuel at idling, check if the needle valve is set too high or if the needle valve assembly is sticking. Also, inspect for a damaged metering system, a worn needle valve, a leaking control diaphragm/cover plate, or an incorrectly assembled metering system.
What to do if my Husqvarna Chainsaw engine starts but stops immediately?
If your Husqvarna Chainsaw starts and then stops, the issue might stem from a few potential problems. Incorrect fuel type could be the culprit, so drain the fuel tank and refill it with the correct fuel. A dirty air filter can also cause this issue, so clean or replace it. Replacing the fuel filter can also resolve this problem.
Why does my Husqvarna Chainsaw have low power?
If your Husqvarna chainsaw has low power, consider these solutions: adjust the H screw, check for a blocked fuel tank vent or fuel filter, and inspect the impulse channel for leaks or blockages. Also, check for a loose cover on the carburettor pump side, a faulty pump diaphragm, and a blocked air filter. Look for a sticking needle valve assembly, leaks in the metering system, an incorrectly assembled metering system, a loose diaphragm rivet, a hole in the diaphragm, and a leaking control diaphragm/cover plate.
What to do if my Husqvarna Chainsaw idles when L screw closed?
If your Husqvarna chainsaw idles when the L screw is closed, check for a worn needle valve, a leaking control diaphragm/cover plate, a needle valve assembly that is sticking, a worn needle valve lever, or a faulty diffuser jet.
General| Engine Power | 3.5 hp |
|---|---|
| Cylinder Displacement | 55.5 cm³ |
| Chain Pitch | 0.325 inches |
| Chain Gauge | 0.058 inches |
| Sound Power Level | 114 dB(A) |
| Sound Pressure Level | 104 dB(A) |
| Warranty | 2 years |
| Weight | 12.8 lbs (without bar and chain) |
| Fuel Tank Volume | 0.9 pt (0.44 l) |
| Oil Tank Volume | 0.7 pt (0.35 l) |
| Bar Length | 20 inches |
To Next Page
