7. Use the hand guard to tighten the chain brake
spring. Connect the hand guard to the chain brake
mechanism and turn clockwise to release the chain
brake.
8. Turn the chain tensioner counterclockwise as much
as you can.
9. Attach the guide bar, the saw chain and the clutch
cover.
10. When the chain brake is assembled, you must do a
function test of the chain brake.
8.3.4 To do a function test of the chain brake
1. Hold the product with 2 hands above a stump or
other stable surface.
WARNING:
The engine must be off.
2. Release the front handle. The guide bar tip falls onto
the stump.
Guide bar length, L
Height, H
15 inch 30-40 cm
3. Make sure that the chain brake engages when the
guide bar tip hits the stump.
8.4 Chain catcher
8.4.1 To replace the chain catcher
WARNING: You must always replace a worn
chain catcher with a new one. Always use
original spare parts.
1. Remove the clutch cover.
2. Remove the screw and the chain catcher.
3. Replace the chain catcher with a new one.
4. Attach the clutch cover.
8.5 Muffler
8.5.1 To disassemble the muffler
WARNING: Do not touch a hot muffler. Risk of
burn injuries.
1. Remove the cylinder cover.
2. Remove the 2 crankcase screws (A) and the 2
cylinder screws (B).
722 - 003 - 26.03.2019 Repair instructions - 21
To Next Page
Loading...
