EasyManua.ls Logo

Husqvarna 545G Mark II - Transportation and Storage; Technical Data

Husqvarna 545G Mark II
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Transportation and storage
Transportation and storage
For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
Always use approved containers for storage and
transportation of fuel.
Empty the fuel and chain oil tanks before
transportation or before long-term storage. Discard
the fuel and chain oil at an applicable disposal
location.
Use the transportation guard on the product to
prevent injuries or damage to the product. A saw
chain that does not move can also cause serious
injuries.
Remove the spark plug cap from the spark plug and
engage the chain brake.
Attach the product safely during transportation.
To prepare your product for long-term
storage
1. Stop the product and let it become cool before you
disassemble it.
2. Disassemble and clean the saw chain and the
groove in the guide bar.
CAUTION: If the saw chain and
guide bar are not cleaned, they can
become rigid or blocked.
3. Attach the transportation guard.
4. Clean the product. Refer to
Maintenance schedule
on page 22
for instructions.
5. Do a complete servicing of the product.
Disposal
Obey the local recycling requirements and applicable
regulations.
Discard all chemicals, such as oil or fuel, at a service
center or at an applicable disposal location.
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
Technical data
Technical data
Husqvarna
545 Mark II
Husqvarna
545G Mark II
Husqvarna
550XP Mark II
Husqvarna
550XPG Mark
II
Husqvarna
550XP Mark II
TrioBrake
Husqvarna
550XPG Mark
II TrioBrake
Engine
Cylinder dis-
placement,
cm
3
50.1 50.1 50.1 50.1 50.1 50.1
Idle speed,
rpm
2800 2800 2800 2800 2800 2800
Maximum en-
gine power
acc. to ISO
7293, kW/hp
@ rpm
2.7/3.6 @
9900
2.7/3.6 @
9900
3.0/4.0 @
10200
3.0/4.0 @
10200
3.0/4.0 @
10200
3.0/4.0 @
10200
Ignition system
1
Spark plug NGK CMR6H NGK CMR6H NGK CMR6H NGK CMR6H NGK CMR6H NGK CMR6H
1
Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder.
34 544 - 010 - 12.01.2023

Other manuals for Husqvarna 545G Mark II

Related product manuals