To Next Page
H
Heidi AndrewsAug 9, 2025
How to fix a clogged air filter in Husqvarna 550 XP Mark II Chainsaw?
- JJose GreerAug 9, 2025
If your Husqvarna Chainsaw's air filter is clogged, clean or replace it.
How to fix a clogged air filter in Husqvarna 550 XP Mark II Chainsaw?
If your Husqvarna Chainsaw's air filter is clogged, clean or replace it.
What to do if Husqvarna Chainsaw engine is flooded?
If your Husqvarna Chainsaw engine is flooded due to repeated starts with full choke, remove and clean the spark plug. Then, put the chainsaw on its side with the spark plug hole facing away from you, and pull the starter rope handle 6-8 times. Finally, reassemble the spark plug and start the chainsaw.
What to do if I used the wrong fuel type in my Husqvarna Chainsaw?
If you've used the wrong type of fuel in your Husqvarna Chainsaw, drain the fuel tank and refill it with the correct fuel.
How to fix a clogged fuel filter in Husqvarna 550 XP Mark II?
If the fuel filter in your Husqvarna Chainsaw is clogged, replace it.
How to tighten a loose spark plug on a Husqvarna Chainsaw?
If the spark plug and cylinder are loose on your Husqvarna Chainsaw, tighten the spark plug.
General| Cylinder Displacement | 50.1 cm³ |
|---|---|
| Maximum Power Speed | 10200 rpm |
| Fuel Tank Volume | 0.53 l |
| Oil Tank Volume | 0.32 l |
| Chain Pitch | 0.325 inch |
| Recommended Bar Length | 13-20 in |
| Chain Gauge | 0.050 in |
| Engine Power | 3.0 kW |
| Power Output | 3.0 kW |
| Weight (without cutting equipment) | 5.0 kg |
