Husqvarna 576 XP/G AT - Page 17

SAFETY EQUIPMENT
English – 17
Fig. 19
B
B
D
C
A
Fig. 20
Fig. 21
Remove the throttle cable and lever. See g. 19
Inspection
Clean all components and check the following:
1. That the throttle cable and lever are undamaged and
run easily.
2. That the lock activation mechanism is not worn.
See g. 19.
Assembly
1. Lubricate all guide pins and joint surfaces using light
oil.
2. Fit the throttle cable and lever (A). Fit the throttle
lever (C) with pivot (B). See g. 20.
3. Fit the spring in the recess in the throttle lock (D).
Hold the spring in place and locate the throttle lock
in the recess in the hand grip.
4. Fit the throttle lock pivot (B) with the help of a driver.
See g. 20.
5. Fit the hand grip insert with a screw, when the
throttle, lever, throttle cable and throttle lock with
spring are correctly tted. See g. 21.