Husqvarna 576 XP/G AT - Lubrication System; Lubrication System Dismantling

LUBRICATION SYSTEM
English – 29
WARNING!
Insufficient lubrication of the chain can
result in the chain breaking, which can
cause serious or even life-threatening
injury.
Lubrication system
!
The lubrication system consists of the following parts:
• Oil pump.
• Suction pipe with lter.
• Oil pipe with seals.
All the above parts are described in sequence under the
headings that follow.
Dismantling
1. Empty and clean the oil tank.
2. Dismantle the following parts:
• Chain and bar. See the Operator's Manual.
• Bar guide plate, clutch drum and the centrifugal
clutch. See page 26, g. 1 and 2.
3. Dismantle the oil pump gear (A). See g. 1.
4. Remove the two bolts (B) and lift up the oil pump
from the crankcase. See g. 2.
5. Use a screwdriver to push up the oil hose at C. Lift
up the hose and pull it out of the oil pump. See g. 2.
6. Use pointed pliers and pull up the suction pipe (D)
with lter. See g. 2.
7. Remove the clip (E) and unscrew the adjuster screw
(F). See g. 3.
8. Use a pair of pliers and push on the pump piston at
G so that the cover plug (H) and pump piston (I) can
be removed. See g. 3.
9. Use a pair of pliers and pull out the spring (K) and 2
washers (J). See g. 3.
Fig. 1
Fig. 2
A
E
F
H
I
J
K
G
Fig. 3
B
B
C
D