SAFETY REGULATIONS
4 – English
WARNING!
The warning text warns of the risk of
personal injury if the instructions are
not followed.
General instructions
The workshop where chainsaw repairs are to be done
must be equipped with safety equipment as set out in
local regulations.
No one may repair the chainsaw unless they have read
and understood the contents of this Workshop Manual.
This Workshop Manual contains the following warning texts
in relevant places. Warning texts are positioned before the
procedures they refer to.
Special instructions
The fuel used in the chainsaw has the following hazardous
properties:
1. The uid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inammable.
The bar, chain and clutch cover (chain brake) must be
tted before the saw is started otherwise the clutch can
work loose and cause personal injury.
Wear ear-muffs when test running.
Do not use the saw until it has been adjusted so that the
chain remains still when idling.
After test running, do not touch the mufer until it has
cooled. Risk of burn injuries.
Insufcient lubrication of the chain can result in the chain
breaking, which can cause serious or even life-threatening
injury.
Ensure that the spring in the starter does not y out and
cause personal injury.
If the spring tension is activated on the starter pulley
when it is to be taken up, the spring can y out and cause
personal injury.
Check that the brake is applied when removing the pressure
spring on the chain brake. Otherwise the pressure spring
can y out and cause personal injury.
After repair, the chain brake must be checked in accordance
with the instructions on page 16.
When replacing the crankshaft bearings note that the
crankcase halves are hot. Wear protective gloves
Do not direct the compressed air jet towards the body
when using compressed air. Air can penetrate into the
blood circulation, which means mortal danger.
NOTE!
This text warns of material damage if the
instructions are not followed.
!
To Next Page
Loading...
