Husqvarna 576 XP/G AT - Starter; Starter Dismantling; Starter Cleaning and Inspection

STARTER
18 – English
WARNING!
If the spring is tensioned on the starter
pulley it can fly up and cause personal
injury.
Wear protective glasses.
WARNING!
If the spring is tensioned on the starter
pulley it can fly up and cause personal
injury.
Wear protective glasses.
Starter
Dismantling
!
Cleaning and inspection
Clean all components and check the following:
1. Starter cord.
2. The dogs on the starter pulley.
3. That the pawls on the ywheel are intact, spring
back towards the centre and move freely.
Fig. 1
Fig. 2
Fig. 3
!
4. Remove the central bolt (C) and take out the washer
and starter pulley (D). See g. 3.
5. If the starter cord is to be replaced, cut it off pull out
the ends from the handle and starter pulley with
pointed pliers.
6. If the spring is to be replaced, remove the screws (E)
and the spring cassette (F).
A
B
E
F
D
C
1. Remove the four bolts holding the starter to the
crankcase and remove the starter. See g. 1.
2. Pull out the handle 20-30 cm and take out the cord
from the slot in the starter pulley. See g. 2.
3. Rotate the starter pulley anticlockwise until the ten
sion on the pulley is released.