Husqvarna 576 XP/G AT - Ignition System Assembly

ELECTRICAL SYSTEM
English – 21
Assembly
Assemble the ignition system as follows:
1. Fit the ywheel on the spindle. Turn it gently until the
key on the ywheel mates with the recess in the
shaft.
2. Fit the ywheel washer and nut. Tighten the nut to
35 Nm. See g. 7.
3. Fit the two pawls on the ywheel. See g. 6.
4. Remove the piston stop.
5. Fit the ignition module (B) without tightening its
bolts. See g. 8.
6. Turn the ywheel so that its magnet (G) comes
opposite the ignition module. See g. 8.
Fig. 7
Fig. 5
Fig. 6
35Nm
A
Fig. 8
7. Insert the feeler gauge ”Air Gap Tool” (0.3 mm)
between the ignition module and the ywheel
magnet. The clearance only applies to the two lower
pegs on the ignition module. See g. 8.
8. Push the ignition module against the ywheel and
tighten the bolts (D) to 4 Nm. See g. 8.
9. Fit the cable guide and press on the ignition cable.
Connect the short-circuit cable to the switch. See
g. 5.
10.Pull out the cable and press home the cable clip (A)
on the ignition module. See g. 8.
11. Fit the remaining parts on the saw. See respective
chapters.
0,3mm
B
G
A
D
Air gap tool