Husqvarna 576 XP/G AT - Carburettor Refitting to Chainsaw

38 – English
CARBURETTOR
Retting to the chainsaw
See g. 20 and 21.
1. Mount the lterholder with carburettor and choke
system. Connect the rear rubber mounts (H).
Check that the choke is tted in the right position in
the partition. See page 47, g. 15.
2. Mount 4 bolts (G) which secure the lter holder,
carburettor and choke system.
3. Mount the fuel pipe (B).
4. Connect the throttle cable (A).
5. Connect the switch wires (E and F).
6. Mount the carburettor control (D).
7. Fit the cylinder cover and air lter. See the
Operator's Manual.
Fig. 20
Fig. 21
G
H
H
B
A
D
F
E