TANK UNIT
English – 43
Cleaning and inspection
Clean all parts and check that the fuel pipe is intact.
Assembly
1. If the chainsaw is tted with hand grip heating, t the
heating element if it has been removed.
See page 22 and 24.
NOTE!
Take care not to damage the fuel pipe and
throttle cable.
2. If the throttle lock has been removed, it should be
retted before the tank unit and engine unit are
assembled. See page 17.
3. Lift the engine unit over the tank unit and push the
fuel, tankvent pipe and throttle cable into their holes
in the bottom of the carburettor space.
4. Fit the bolts (E and H). See g. 2. Tighten the bolts
to the torque in the service data, page 10 and 11.
5. Fit front handle with the bolts (D, F and G). See
g. 2. Tighten the bolts to the torque in the service
data, page 10 and 11.
6. Fit the fuel pipe (B) on the carburettor and tankvent
pipe (C). See g. 1.
7. Insert the throttle cable casing in the attachment and
hook on the throttle cable (A) on the carburettor.
See g. 1.
8. Fit the cylinder cover, guide chain and bar.
See the Operator's Manual.
To Next Page
Loading...
