Husqvarna 576 XP/G AT - Page 49

PISTON and CYLINDER
English – 49
Lx2
Mx2
Q
O
N
P
R
Fig. 14
Fig. 15
11. Fit the lterholder with choke on carburettor. Use
long screws (L) on the upper part and short screws
(M) on lower part. See g. 14.
12. Fit carburettor with lter holder on manifold.
• Fit choke shaft (P) in notch.
• Slide choke rod (N) in guide (O).
• Push in the choke rod (Q).
• The impuls nipple should meet the impuls hose
(R).
• Tighten the screws 2 Nm.
• Connect the rear rubber mount (S). See g. 15.
13. Assemble the following parts:
• Mufer. See page 15.
• Cylinder cover. See the Operator's Manual.
• Chain and bar. See the Operator's Manual.
14. If a new piston and/or cylinder is tted the chainsaw
should be run-in for 3-4 hours. See carburettor
settings on pages 39 and 40.