Husqvarna 576 XP/G AT - Page 9

SERVICE TOOLS
English – 9
Item Description Used for Order No.
1 Piston stop Locking the crankshaft 504 91 06-05
2a Cover plate, exhaust Sealing the exhaust port 502 54 11-02
2b Cover plates, inlet kit Sealing the intake system 502 52 48-01
3 Pressure testing device Produce pressure when
leakage testing 531 03 06-23
4 Crankecase splitting tool Dismantling the crankshaft 502 52 49-01
5 Puller Pulling bearing of crankshaft 504 90 90-01
6 Flywheel puller kit Dismantling of the ywheel 502 51 49-02
7 Piston assembly kit Assembling the piston 502 50 70-01
8 Crankshaft assembly tool Assembling the crankshaft 502 50 30-20
9 Seal ring extractor Pulling of seal ring 504 91 40-01
10 Pressure test adapter Pressure testing cylinder 503 84 40-02
11 Feeler gauges ignition gap Air gap tool 502 51 34-02
12 Tachometer Checking engine rpm 502 71 14-01
13 Test spark plug Checking the ignition module 502 71 13-01
14 Clutch tool Dismantling of clutch 502 52 22-01
15 Assembly pliers Assembly of spark plug cap 502 50 06-01
16 Hook for fuel lter Removing fuel lter 502 50 83-01
17 Assembly xture Assembling chain saw 502 51 02-01
18 Hexagonal screwdriver For M4 screws 502 50 86-01
18 Hexagonal screwdriver For M5 screws 502 50 87-01
18 Hexagonal screwdriver For M6 screws 502 50 88-01
19 Allen key For M4 screws 502 50 19-01
19 Allen key For M5 screws 502 50 18-01
19 Allen key For M6 screws 502 50 64-01
20 Adjustment screwdriver Adjustment of the carburettor 530 03 55-60
21 Adjustment screwdriver Adjustment of the carburettor 501 60 02-03
22 Adjustment screwdriver Adjustment of the carburettor 531 00 48-63
23 Adjuster kit, 3 pcs. Adjustment of the carburettor 585 07 17-01
The tools listed here are service
tools intended for use on the
chainsaw in question. In addition
to these tools, a standard set of
hand tools is required.
14 15 16 17
18 19
M4
M5
M6
M4
M5
M6
8
9
0
7
6
5
8
9
0
7
6
5
8
9
0
7
6
5
23
20
21 22
4 mm 2 mm