What does it mean if my Husqvarna AUTOMOWER 435X AWD says 'Guide not found'?
If your Husqvarna Lawn Mower displays 'Guide not found', it means the product is no longer receiving signals from the guide wire. Check the connection of the guide wire to the charging station.
Why does my Husqvarna AUTOMOWER 435X AWD Lawn Mower have a 'Battery problem'?
If your Husqvarna Lawn Mower displays a 'Battery problem', the battery may not be connected properly or could be faulty. Dismantle the product and check that the battery is properly connected to its connector. Ensure you are using only original batteries recommended by the manufacturer. If the battery is faulty, it should be replaced.
Why does my Husqvarna AUTOMOWER 435X AWD need manual charging?
If your Husqvarna Lawn Mower requires manual charging, it may be set to the Secondary area operating mode. Put the product in the charging station. This is normal behavior, and no further action is required.
What to do if Husqvarna AUTOMOWER 435X AWD stopped because of grass around the drive wheels?
If your Husqvarna Lawn Mower stops due to grass or other objects obstructing the drive wheels, inspect the wheels and clear away any grass or obstructions. Then, restart the mower. Should the problem persist, contact your local Husqvarna representative for further assistance.
What to do if my Husqvarna AUTOMOWER 435X AWD says 'Outside working area'?
If your Husqvarna Lawn Mower is operating outside the designated working area, several issues could be the cause. Check that the boundary wire is connected correctly to the charging station. Also, verify that the boundary wire has been laid according to the instructions and is not too close to the edge of the working area, or that the working area doesn't slope too much at the boundary wire. Ensure the boundary wire isn't laid in the wrong direction around an island. If there are disturbances from magnetic objects or buried cables, try moving the boundary wire or creating additional islands. If the product finds it hard to distinguish the signal from an installation close by, put the product in the charging station and generate a new loop signal.
Why is there 'No power in charging station' for my Husqvarna Lawn Mower?
If there is 'No power in charging station' for your Husqvarna Lawn Mower, the power supply unit may be wrong or faulty, so check the power supply and replace it if necessary. There may be a power failure, so find and rectify the cause. Ensure there is contact between the contact plates and the charging plates; if they appear burnt or coated, clean them. The circuit board in the charging station may be faulty. The cable to the battery or the battery may be faulty, so replace the cable or the battery.
What does it mean if my Husqvarna AUTOMOWER 435X AWD Lawn Mower has a 'STOP button defect'?
If your Husqvarna Lawn Mower indicates a 'STOP button defect', the STOP button sensor may be malfunctioning, so the application circuit board should be replaced. The start/stop handle may need to be replaced. Also, check the magnet placed in the start/stop handle; it may be missing or inverted.
Why is my Husqvarna AUTOMOWER 435X AWD stuck in the charging station?
If your Husqvarna Lawn Mower is stuck in the charging station, there might be an object preventing it from leaving, so remove the object. Additionally, the product may be sliding on the baseplate, so clean the baseplate.
What to do if my Husqvarna AUTOMOWER 435X AWD Lawn Mower has a rear wheel drive problem?
If your Husqvarna Lawn Mower is experiencing a rear wheel drive problem, the wheel motor may be faulty, so check the wheel motors’ function when idling. The rear motor control board may be faulty, and the cabling to the wheel motor may be damaged. Check whether the damage is repairable; otherwise, replace the wheel motor.
Why does my Husqvarna AUTOMOWER 435X AWD Lawn Mower say 'Mower lifted'?
If your Husqvarna Lawn Mower displays 'Mower lifted', it could be because the lift sensor has been activated due to the product getting stuck, so free the product. Also, check the magnets placed in the front and rear bodies; one of the lift sensor magnets might be inverted or missing. The lift sensor may be faulty.
General| Cutting Width | 22 cm |
|---|---|
| Cutting Height, Min-Max | 30-70 mm |
| Battery Type | Li-Ion |
| Typical Charging Time | 30 min |
| Typical Mow Time on One Charge | 100 min |
| Product Size, LxWxH | 93x55x29 cm |
| Maximum Slope Performance Inside Installation | 70% |
| Working Area Capacity | 3500 m² |
| Battery Voltage | 18 V |
| Battery Capacity | 5.0 Ah |
| Guide Wire | Yes |
| GPS-assisted Navigation | Yes |
| Lift Sensor | Yes |
| Tilt Sensor | Yes |
| Ultrasonic Sensor | Yes |
| Connectivity | Bluetooth, Cellular |
| Weather Resistance | Yes |
| Warranty | 2 years |
| Blade Type | Pivoting Razor Blades |
To Next Page
