Message Cause Action
No loop signal
The power supply or the low-voltage
cable is not connected.
Examine the LED status on the charg-
ing station. If there is no power to the
charging station, the LED is not lit. Ex-
amine the wall socket connection and if
a residual-current device is engaged.
Make sure that the low-voltage cable is
connected to the charging station.
The power supply or the low-voltage
cable is damaged.
Replace the power supply or low-volt-
age cable.
The boundary wire is not connected to
the charging station.
Make sure that the boundary wire con-
nectors are fitted properly to the charg-
ing station. Replace connectors if dam-
aged. Refer to
To install the boundary
wire on page 22
.
Boundary wire broken. Examine the LED on the charging sta-
tion. If the LED indicates that there is a
break in the boundary wire, find out
where the break is. Replace the dam-
aged section of the loop with a new
loop wire. Use an original coupler to
make a splice of the loop ends. Refer
to
Find breaks in the loop wire on page
54
.
ECO mode
is activated and the product
has attempted to start outside the
charging station.
Put the product in the charging station.
Start the product and close the hatch.
Refer to
To start the product on page
38
.
The boundary wire is crossed on its
way to and from an island.
Make sure that the boundary wire is put
down correctly. Refer to
To make an is-
land on page 19
.
The product does not find the loop sig-
nal from the charging station.
Put the product in the charging station
and generate a new loop signal. Refer
to
To create a New loop signal on page
28
.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
Try to move the boundary wire and/or
make more islands in the work area to
increase the signal strength.
Wrong PIN code
An incorrect PIN code has been en-
tered. 5 tries are permitted, and the
product is then blocked for a period of
time.
Enter the correct PIN code. Contact
your local Husqvarna representative if
you forget the PIN code.
1230 - 002 - 30.03.2020
Troubleshooting - 45
To Next Page
Loading...
