BEFORE STARTING/AFTER STARTING
28
Before Each Use
1. Be sure chain brake is operating properly and
undamaged.
Note: Your Operator's Manual gives instructions on
how to properly test the chain brake.
2. Check rear-hand guard for damage.
3. Be sure chain catcher is in place and undamaged.
4. Be sure throttle trigger lockout is operating properly
and undamaged.
5. Be sure ignition switch is operating properly and
undamaged.
6. Be sure anti-vibration components are in place and
undamaged.
7. Be sure muffler is in place and undamaged.
8. Be sure all handles are clean and free from oil.
9. Check entire saw for loose fasteners and damaged or
missing components.
Carrying The Saw
1. Always turn off the engine before walking with the
saw.
2. Do not leave the saw unattended while the engine is
running.
3. Install guide bar scabbard on guide bar before
carrying saw.
4. Carry the saw with the bar pointing to the rear and
with the muffler away from you.
5. Engage the chain brake when mowing between work
areas.
FRONT HANDLE
IGNITION SWITCH
THROTTLE
TRIGGER
LOCKOUT
FRONT HAND
GUARD
CHAIN BRAKE CHAIN
CATCHER
REAR HAND
GUARD
GUIDE BAR
SCABBARD
MUFFLER
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
