To Next PageTo Next PageWhat to do if the chain does not rotate while throttling up Husqvarna K6500 II Chain?
If your Husqvarna Chainsaw chain doesn't rotate when throttling up, it could be due to a couple of reasons. Check if the chain tension is too tight and adjust it according to the instructions in the section ”Assembling and adjustments.” Also, verify that the diamond chain is properly installed.
Why are the vibration levels too high on my Husqvarna K6500 II Chain Chainsaw?
If your Husqvarna Chainsaw experiences high vibration levels, several factors could be responsible. First, verify that the guide bar and diamond chain are correctly installed and free from damage. If the diamond chain is defective, replace it with a new one. If the vibration persists, the vibration damping elements may be defective, and you should contact your service agent.
What to do if the diamond chain snaps or jumps off my Husqvarna K6500 II Chain Chainsaw?
If your Husqvarna Chainsaw's diamond chain snaps or jumps off, it could be due to several reasons. Check and adjust the chain tension, referring to the instructions in the section ”Assembling and adjustments.” Also, ensure that you are not inserting the saw into a slot narrower than the diamond chain segments, consulting the section "Operation." Finally, avoid letting the saw bounce and chatter by applying enough feed pressure while cutting.
Why is there premature chain stretch on my Husqvarna Chainsaw?
Premature chain stretch in your Husqvarna Chainsaw can be caused by insufficient water pressure. Increase the water pressure to resolve this issue.
What to do if my Husqvarna K6500 II Chain has poor cutting speed?
If your Husqvarna Chainsaw has poor cutting speed, it may be because the diamonds are glazed or the feed pressure is too low. To resolve this, cut in a soft abrasive material such as sandstone or brick for a short while.
Specifies the intended materials for cutting with the diamond chain saw.
Step-by-step guide for fitting and changing saw components.
Detailed instructions on how to properly tension the diamond chain.
Lists the required personal protective equipment for safe operation.
Provides essential safety guidelines for operating the machine.
Safety measures related to the work environment and area.
Critical safety instructions regarding electrical connections and usage.
Personal safety practices and common sense during operation.
Importance and function of water cooling and dust suppression.
Explains fundamental techniques for safe and effective operation.
Explains the machine's gradual start and overload protection features.
Explains kickback causes, effects, and avoidance.
How to prevent climbing kickback.
Explains pinching kickback and saw control.
Step-by-step guide for starting the machine.
How to safely stop the machine and turn it off.
A table listing common problems, their causes, and potential solutions.
General