English – 21
MAINTENANCE
General
Let your Husqvarna dealer regularly check the machine and make essential adjustments and repairs.
Maintenance schedule
In the maintenance schedule you can see which parts of your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated based on daily use of the machine, and may differ depending
on the rate of usage.
*See instructions in the section "Machine’s safety equipment".
** See instructions in the section "Diamond chains", "Assembling and adjustments" and ”Maintenance”.
*** Always change to a new rim sprocket for every new diamond chain. See instructions in the section ”Diamond chains”
and ”Assembling and adjustments”.
Cleaning and lubrication
External cleaning
• Clean the machine daily by rinsing it with clean water after the work is finished.
Lubrication
• To prevent corrosion, oil the diamond chain and guide bar after use.
!
WARNING! The user must only carry out the maintenance and service work described in this
Operator's Manual. More extensive work must be carried out by an authorized service workshop.
Inspection and/or maintenance should be carried out with the motor switched off and the plug
disconnected.
Wear personal protective equipment. See instructions under the ”Personal protective equipment”
heading.
The life span of the machine can be reduced and the risk of accidents can increase if machine
maintenance is not carried out correctly and if service and/or repairs are not carried out
professionally. If you need further information please contact your nearest service workshop.
Daily maintenance
Weekly maintenance/40
hours
After each diamond
chain (consumed)***
Cleaning External cleaning
Functional inspection
General inspection
Vibration damping
system*
Splineway / Rim sprocket
Water system Guide bar
Throttle trigger*
Throttle lockout*
Hand guard, rear right
hand guard, cover and
spray guard*
Guide bar and diamond
chain**
!
WARNING! Do not use high-pressure washers to clean the machine.
To Next Page
Loading...
