DIAMOND CHAINS
English – 9
Glazing
After cutting extremely hard concrete or stone the
diamond segment may lose some or all of its cutting
capacity. This can also occur if you are forced to cut with
a low partial pressure (the diamond chain runs against the
workpiece along the entire length of the bar). The solution
to the problem is to cut in a soft abrasive material such as
sandstone or brick, for a short while.
Transport and storage
• After completed work, the diamond chain saw shall be
run with water pressure for at least 15 sec. to clean
bar, chain and drive mechanism of particles. Rinse the
machine with water. If the machine is not to be used
for a while, we recommend oiling the chain and bar to
prevent corrosion.
• Inspect all cutting equipment for transport and storage
damage.
To Next Page
Loading...
