KEY TO SYMBOLS
2 – English
Symbols on the machine:
WARNING! Chain saws can be
dangerous! Careless or incorrect use
can result in serious or fatal injury to
the operator or others.
Please read the operator’s manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European
Community’s Directive. The machine’s
emission is specified in the Technical
data chapter and on the label.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May
cause serious personal injury.
Decompression valve:
The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Ignition; choke:
Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Air purge
Adjustment of the oil pump
Refuelling.
Chain oil fill.
If your machine bears this symbol
it is equipped with a catalytic
converter.
Chain brake, activated (right)
Chain brake, not activated
(left)
If your machine bears this symbol it
is equipped with heated handles.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
To Next Page
Loading...
Need help?
General
