Husqvarna P 520D - Product Assembly Procedures; Assembly Introduction and Belt Warnings; Attaching the Combi Cutting Deck

12 – English
Chassis
9. Remove ve screws (1) so that the base plate
(2) can be loosened from the front edge.
1
2
8095-276
1. Screw
2. Base plate
10. Remove ve screws (1) so that the front edge of
the base plate (2) can be loosened.
1. Reverse pedal
2. Pedal cable
3. Clevis pin
4. Split pin
5. Torsion spring
8095-325
3 4 5
1
2
11. Press out the pedal shaft (9) and dismantle one
pedal arm at a time. Lift up the base plate to
allow the reverse pedal to pass.
1. Link arm
2. Rubber seal
3. Profile washer
4. Nut
5. Return spring
6. Split pin
7. Clevis pin
8. Forward pedal
9. Pedal shaft
10. Retaining ring
11. Washer
12. Pedal cable
8095-324
1 2 3
9
8
7
6
4
5
11
10
12
12. Pull the bushings (1) out of the pedal arms.
13. Fit new bushings.
8095-331
1
1
2
1
3
1
1. Bushing
2. Forward pedal
3. Reverse pedal
IMPORTANT!
It is a good idea to fit the cable before the link
arm is refitted.
14. Ret the pedal bracket in the reverse order.
15. Lubricate the bushings through the grease
nipples.