Husqvarna P 520D - Fuel, Battery, and Transport Safety Instructions; Fuel Safety and Refueling Guidelines; Battery Safety and Handling; Transport Safety Precautions

English – 11
Chassis
Changing Pedal Bracket Bushings
Tools Dimension Quantity
Groove joint
pliers
1
Combination
wrench
13 mm 1
Combination
wrench
15 mm 1
Socket wrench 13 mm 1
Screw driver 5 mm 1
1. Start the machine and raise the lift arms.
2. The lift arms can y up if the lever for the
hydraulic lift is unintentionally operated. Prevent
this by pulling out the retainer spring (6) and
removing the clevis pin (7) for the auxiliary lift
spring (8).
8095-321
2
3
4
1
5
6
7
8
1. Reverse pedal
2. Forward pedal
3. Half speed catch.
4. Link arm
5. Cable
6. Retainer spring
7. Clevis pin
8. Auxiliary lift spring
3. Lower the lifting arms.
4. Turn off the machine and make sure it can not
be restarted.
5. Dismantle the pedal cable (2) split pin (4) and
clevis pin (3).
8095-325
3 4 5
1
2
1. Reverse pedal
2. Pedal cable
3. Clevis pin
4. Split pin
5. Torsion spring
6. Dismantle the pedal cable (12) by removing
the split pin (6) and the clevis pin (7).
7. Loosen the link arm (1) by removing the nut (4).
Hold the prole washer (3) with a 13 mm
combination wrench so the bolt does not turn.
Take care not to damage the rubber seal on the
link arm.
8. Dismantle the retaining ring (10) and one
washer (11).
8095-324
1 2 3
9
8
7
6
4
5
11
10
12
1. Link arm
2. Rubber seal
3. Profile washer
4. Nut
5. Recoil spring
6. Split pin
7. Clevis pin
8. Forward pedal
9. Pedal shaft
10. Retaining ring
11. Washer
12. Pedal cable