English – 51
Hydraulic System
10. If the transmission is being changed, the
devices for adjusting the wheel speed (1) and
damper for the rear wheels speed (2) must be
transferred to the new transmission as below:
IMPORTANT!
Do not get the components mixed up. It is a
good idea to dismantle and reassemble one
adjustment device at a time before work on
the next adjustment device commences.
8095-319
1
3
2
1. Wheel speed adjustment 2. Rear wheel speed
damper
11. Dismantle the device for rear wheel speed
damper by removing the screw (1) and nut (6).
Note the position of the spring (4) and washer (5).
12. Dismantle the link head (3) with nut (2).
13. Dismantle the device for adjusting the wheel
speed (13) by removing nut (12) and screw (8).
14. Dismantle the plates (10) only if any measures
need to be taken (e.g. cleaning).
15. If the transmission is being changed, dismantle
the hydraulic connection adapters.
1. Screw
2. Nut
3. Link head
4. Spring
5. Washer
6. Nut
7. Nut
8. Screw
9. Link head
10. Plate
11. Bushing
12. Nut
13. Wheel speed adjuster
8095-338
7
8
10
9
12
11
13
1
3
2
4
6
5
To Next Page
Loading...
