Moving Machine By Hand
When pushing or pulling the mower, engage the
bypass linkages with the hydro release levers.
The levers are located on each side of the rear of
the unit below the engine plate.
WARNING! Bypass linkages are located
close to the mufer. To prevent burns, the
engine should be shut off and allowed to cool
before the bypass linkage levels are handled.
1. Raise the deck to the highest (transport)
position.
2. Pull the bypass linkages up and out of the
keyhole slots. Release the lever with the head
outside the bracket and held into the bypass
setting.
3. To reengage the hydro to drive, reverse the
procedure.
WARNING! Do not make adjustments
unless:
• the engine stopped,
• the ignition key removed,
• the park brake engaged
20
OPERATION
To Next Page
Loading...
