English – 13
PRESENTATION
ROPS (Roll Over Protective
Structure)
ROPS is a protective frame that reduces the risk of injury in
the event of overturning. Use ROPS and a safety belt when
driving on slopes.
The frame can be folded down.
• Remove the two pins that hold the frame and fold it
backwards.
ROPS check
• Check that the ROPS is securely attached and not
damaged.
Safety belt
The seat belt protects the driver from injury in case of crashes
or overturning.
The belt may only be used when the bar (ROPS) has been
raised.
Seat belt check
Check regularly that the seat belt is intact and secured
correctly.
Cutting unit
P524 can be equipped with three different cutting units.
Combi 103, Combi 112 and Combi 122.
The Combi-unit, equipped with a BioClip-plug, finely chops
the cuttings to fertiliser. Without the BioClip-plug the unit
works in the same way as a rear ejection unit. The rear ejector
ejects the clippings behind the unit without finely chopping
them.
Lever for hydraulic lift of
attachments
The lifting lever is used to put the cutting unit in either the
transport or mowing position when hydraulic pressure is
available.
The lever has four different positions.
• Position 1 is the neutral position.
• Position 2 lowers the cutting unit with spring return to the
neutral position
• Position 3 is floating where the lever stops. The unit is
lowered to the automatically floating position, which
means that the cutting unit follows the contours of the
ground.
• Position 4 raises the cutting unit with spring return to
neutral position.
When cutting the lever should be set directly to the floating
position (3).
Lifting the Cutting Unit (Transport
Position)
Turn off the cutting unit using the PTO button.
!
WARNING! If the frame is folded down the
safety belt should NOT be used.
!
WARNING! If the frame is folded up, the
safety belt must be used.
To Next Page
Loading...
