36 – English
Lubrication
Links and joints in the cutting
adjustment
• Lubricate the links and the joints for the cutting height
adjustment stay behind the right front wheel.
Driver seat
• Fold up the seat.
• Lubricate the lengthways adjustment runners with oilcan.
Throttle and choke cables, lever
bearings
• Remove the right side cover on the rear body.
• Lubricate the cables’ free ends with the oilcan, even those
by the engine.
• Move the controls to the end points and lubricate again.
• Lubricate the joints, catches, and bearings for the cutting
unit’s control levers with oil.
• Refit the cover.
Lubricate the hydrostatic cable with
links
• Lubricate the joints and bearings on the left side with oil.
• Remove the rubber casing and lubricate the hydrostatic
transmission cable with oil.
• Press the pedal a few times, lubricate again and refit the
rubber casing.
Steering cylinder
The steering cylinder has two grease nipples, one on each
end.
• Lubricate with a grease gun until the grease is forced out.
Joint bearing
• Grease the waist section of joint bearing Lubricate with a
grease gun until the grease is forced out.
Link brace
• 2 grease nipples, one on each side. Lubricate with a
grease gun until the grease is forced out.
To Next Page
Loading...
