20 – English
Maintenance
1)
If the machine is used daily it should be lubricated twice a week.
2)
Conducted by authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
Lubricate the hydrostatic cable with links X
Check the parking brake X
Lubricate the parking brake wire X
Lubricate throttle control X
Lubricate choke control X
Lubricate the chain in the frame tunnel X
Check the V-belts O
Checking the transmission oil level X
Checking and adjusting the choke wire X
Tighten the nuts and screws O
Checking and adjusting of throttle wire O
Replace the fuel filter. X X X
Replace the spark plug. X X
Replace the engine oil filter X
Check/adjust front and rear wheel rotation
speed according to the service schedule
4)
O O O O O
IMPORTANT! When the machine is in operation the hoses are under high pressure. Do not try to connect or disconnect the hoses
when the hydraulic system is operational. This can result in serious personal injuries.
!
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
To Next Page
Loading...
