English – 15
PRESENTATION
Cutting unit
The Rider 15V2 can be fitted with three different
cutting units.
Side ejector - 970 mm/38"
Combi - 1030 mm/41"
Combi - 1120 mm/44"
See “Maintenance \ Checking the Blades” for
identification of the cutting unit.
The combi deck functions as a mulching deck when
a bio-clip plug is mounted. Without the plug, the
deck will function as a rear ejection deck.
Lifting of the cutting unit (transport position)
Lift lever for cutting unit
The lift lever is used to set the cutting unit in
transport or cutting position.
If the lever is pulled back the unit will lift up and the
blades will automatically stop rotating (transport
position).
If the lock button is pressed and the lever is moved
forward the unit will be lowered and the blades will
automatically start rotating (cutting position).
The lever can also be used to temporarily regulate
the cutting height, e.g. for a small mound in the
lawn.
6017-214
6017-129
6017-130
Lowering of the cutting unit (cutting position)
To Next Page
Loading...
