Husqvarna Rider 216 AWD User Manual

English – 9
MA CHINE´S SAFETY EQ UIPMENT
General
Ignition ke y
The ignition k ey is used to turn the engine on and off together
with all electrical functions.
1 STOP - the machine is powered down
2 - Neutral
3 START - spring-back ignition position
Ignition ke y check
• Check the ignition key by starting and stopping the
engine. See instructions under the heading Starting and
stopping.
• The engine should start when the ignition key is turned to
START (3).
• The engine should stop immediately when the ignition key
is turned to STOP (1).
Saf ety circuit
The machine has a saf ety circuit that triggers whenever the
driver gets off the seat while the blades are engaged. The
safety circuit is also tripped when the parking brake has not
been applied and the driver rises from the seat.
Drive to the blades is stopped when the safety circuit is
tripped. There is a short delay to prevent stopping if the driver
bounces on the seat.
The engine can only be started when:
• The cutting deck is raised and the parking brake is
applied.
The engine should stop when:
• The cutting deck is lowered and the driver rises from the
seat.
• The cutting deck is in its raised position, the parking brake
is not applied and the driver rises from the seat.
Saf ety circuit check
• Check daily to ensure that the safety system works by
attempting to start the engine when one of the conditions
above is not met. Change the conditions and try again.
Speed limiter
The speed of the machine is steplessly regulated with tw o
pedals. Pedal (1) is used to drive forwards, and pedal (2) to
drive backwards.
The machine is braked when the forward pedal is released.
The reverse pedal can also be used if additional braking
power is required.
Accelerator c heck
• Ensure the forward and reverse pedals can be operated
freely.
• Ensure the machine brakes when the forward pedal is
released.
!
W ARNING! Never use a machine that has
faulty safety equipment!
If your machine fails any checks contact
your service agent to get it repaired.
START
STO
P
1
2
3
2
1

Husqvarna Rider 216 AWD Specifications

General

Cylinders	2
Battery type	Lead-Acid
Battery voltage	12 V
Blades	3
Hour meter type	Digital
Seat material	Vinyl
Transmission type	Hydrostatic
Drive method	All-Wheel Drive
Uncut circle	30 cm
Tires rear	170/60-8