2. Attach the battery connector to the crankcase.
3. To prevent corrosion on the main switch connector,
put grease on the pins before you attach the main
switch.
4. Connect the connectors (B) and attach the
connector (C) to the main switch.
5. Put grease on the connector and the yellow wires.
6. Put the cables and the main switch in the crankcase.
Note: Make sure that you put the cables correctly to
prevent damage to the cables when the product is
assembled.
5.15 Main switch S/N 20180600615-
5.15.1 To disassemble the main switch
CAUTION: Do not pull the cables.
1. Remove the drive wheel cover, the saw chain and
the guide bar. See
To remove the drive wheel cover
and guide bar on page 9
2. Disassemble the crankcase. See
To disassemble
the crankcase on page 9
3. Remove the main switch from the crankcase.
4. Carefully free the catches (D) on each end of the
connector with a small screwdriver.
5. Disconnect the connector (C).
14 - Repair instructions 539 - 003 - 05.12.2018
To Next Page
Loading...
