Husqvarna T536LiXP - Replacing the Keypad S;N -20180600615

5. Disconnect the wire bracket from the control unit.
First holder (A) and then holder (B).
A
B
6. Remove the motor connector from the holder.
Remove the control unit and battery terminal.
5.17.2 To assemble the control unit
1. Attach the wires to the control unit. Make sure that
the sealing and bracket is correctly attached. First
attach (A) and then (B).
B
A
2. Attach the control unit and the battery terminal to the
crankcase.
3. Put the motor connector in the holder. Assemble the
cables as shown in the illustration.
4. Make sure that the gray area in the illustration (A) is
free from cables. This is the battery ejector (B).
B
A
Note: There is a risk that cables around the battery
ejector get caught between other parts when the
battery is attached.
5. Assemble the product. See To assemble the drive
wheel cover and guide bar on page 9 , To assemble
the crankcase on page 9 and To assemble the
motor on page 12 .
5.18 Replacing the keypad S/N
-20180600615
5.18.1 To replace the keypad
CAUTION: Do not bend the keypad when you
assemble.
1. Remove the drive wheel cover, saw chain and guide
bar. See To remove the drive wheel cover and guide
bar on page 9 .
2. Disassemble the crankcase. See To disassemble
the crankcase on page 9 .
3. Carefully remove the keypad.
539 - 003 - 05.12.2018 Repair instructions - 17