8. Remove the hose from the external side of the
crankcase. Steer it through the hole and remove it at
the same time.
5.21.2 To assemble the oil pump
1. Lubricate the parts.
2. Steer the hose through the hole in the crankcase.
Pull it out with your fingers or round nose pliers.
3. Put the hose in the groove on the external side of
the crankcase.
4. Assemble the chain guide plate.
5. Put the cylinder and the lubrication shaft in the hole
in the hose. Put the components in the crankcase.
6. Assemble the oil pump cover.
7. Assemble the motor. See
To assemble the motor on
page 12
.
8. Assemble the crankcase. See
To assemble the
crankcase on page 9
.
9. Fill with chain oil.
5.22 Chain tensioner T536LiXP/T535i XP
5.22.1 To disassemble components of the chain
tensioner T536LiXP/T535i XP
1. Disassemble the drive wheel cover, saw chain and
guide bar.
To remove the drive wheel cover and
guide bar on page 9
2. Remove the screws and remove the cover.
3. Remove the the chain tensioner and adjustment
screw from the drive wheel cover.
539 - 003 - 05.12.2018 Repair instructions - 21
To Next Page
Loading...
